Precision-control-systems 5620 Manual do Utilizador descarregar pdf (Página 12)

Page 12 of 14

13BInstalling an Optional Remote Timer-Start Switch

1. Remove the plug from the upper circuit board (Fig. 3-4).

2. Pass the Remote Timer-Start switch wire through the top strain relief clamp.

3. Fasten the two wires from a normally-open switch into the small compression lugs on

the plug and tighten the screws.

4. Re-insert the plug onto the board.

5. Tighten the screws on the strain relief clamp to secure the wire.

6. Replace the top cover and the four Phillips screws.

Figure 3-4 Installing the Remote Timer-Start switch to the upper circuit board.

1 2 ... 7 8 9 10 11 12 13 14

Sem comentários

Precision-control-systems 5620 Manual do Utilizador Página 12